Guitar Fuzz Effects Pedal Kit - Silicon NPN

Sub D Socket with turned pin solder lugs. Standard 15 way (2 rows)

Plastic Cover with screws/hardware for standard 15 way D connectors (D15F & D15M)

Black Plastic Knob with Red Insert & White Pointer. 

Metal Bush with grub-screw. For 6.3mm spindle

Diameter 10mm top,15mm bottom, Height 20mm

Black Plastic Knob with Yellow Insert & White Pointer. 

Metal Bush with grub-screw. For 6.3mm spindle

Diameter 10mm top,15mm bottom, Height 20mm

Black Plastic Knob with Blue Insert & White Pointer. 

Metal Bush with grub-screw. For 6.3mm spindle

Diameter 10mm top,15mm bottom, Height 20mm

Black Plastic Knob with Black Insert & White Pointer.

Metal Bush with grub-screw. For 6.3mm spindle

Diameter 10mm top,15mm bottom, Height 20mm

Guitar Fuzz Effects Pedal Kit with Authentic Newmarket Germanium Transistors

This kit is based on the legendary fuzz face pedal. Instead of ultra rare germanium transistors, it uses new old stock Newmarket PNP germanium transistors to give you that classic germanium fuzz, while keeping the cost down. This project is ideal if you're looking to get into guitar pedal building. A schematic and layout diagram will be provided with the kit.
 

The following components are included in this kit:

• Circuit Layout Diagram + Schematic x 1
• Volume (500kΩ LOG) and fuzz (5kΩ LIN) potentiometers x 1 each
• NKT128 Transistors x 2
• CPB10N Boxpoly 10nF Capacitor x 1
• 2.2µF Electrolytic Capacitor x 1
• 22µF Electrolytic Capacitor x 1
• 330Ω Metal Film Resistor x 1
• 33kΩ Metal Film Resistor x 1
• 100kΩ Metal Film Resistor x 1
• 8.2kΩ Metal Film Resistor x 1 
• 6.3mm (1/4") Open Jack Socket x 2
• PP3 9V Battery Snap x 1
• DPDT Latching Footswitch x 1
• 9x25 Stripboard x 1

To assemble this kit, you will need the following tools:

• Soldering iron and solder
• Side cutters
• Track cutter
• Drill (optional - only needed if you want to use an enclosure)

Tesla Coil Kit with Audio Input

Amaze your friends with this cool musical tesla coil kit. When fully assembled, this module will act as a tesla coil which will play audio through the arcs when an audio source (e.g. phone, laptop) is connected to the audio input of the coil. It runs on 15-24V DC, either from batteries or a power supply (not included). 

 

Power Input: 12-24V DC, 2.1 x 5.5mm 
Audio Input: 3.5mm stereo socket (only the left channel is active)
PCB Dimensions: 80 x 38mm

Please note: Tesla coils produce very high voltages; do not touch this device when it is turned on! This device produces intense radio frequency interference which can affect any electronic devices near it (e.g. pacemakers). Lastly, the arcs produced by Tesla coils can ignite flammable objects; keep all flammable objects away from the Tesla coil.