|Now FREE Delivery on UK mainland orders over £30+VAT|
Carbon Film Resistor 1/4 Watt 5% 10 Pack. 220 ohms
UNO R3 Arduino-compatible board with the ATMega328P, ATMega16U2 and CH340G serial converter
Since Arduino is an "Open Source" hardware as well as software anyone can duplicate the Arduino Uno R3 boards exactly, even using original parts, this means we are able to supply this Arduino compatible board at a fraction of the cost of the original but still working identicaly to the original.
The UNO is the best board to get started with electronics and coding. If this is your first experience tinkering with the platform, the UNO is the most robust board you can start playing with. The UNO is the most used and documented board of the whole Arduino family.
Arduino Uno is a microcontroller board based on the ATmega328P (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. The development board has everything needed to support the microcontroler to help you create an endless amount of projects and if you are just starting then the worldwide Arduino community is full of ideas, guides and help to get you started or help you complete your project.
1 x Arduino Compatible Uno R3 development board
1 x USB Cable
Arduino Quick Start Guide
Installing the Arduino IDE
Connecting the Arduino to a computer
Installing Arduino Libraries
Solderless Male to Female Jumper Leads - set of 40
This set of coloured male to female jumper leads can be used intact, or peeled appart into small sets or single leads. Great for prototyping with Arduino, Raspbery Pi and other projects
Keep track easily with 10 different colours for quick fault finding.
4 of each: Red, Orange, Yellow, Green, Blue, Grey, Purple, Brown, Black and White
Each length: 200mm
RGB full colour 5MM LED module for Arduino and other microcontroler projects
This module has a 5MM RGB LED that can be used to create virtually any colour by varying the intensity of the 3 colours by using the PWM output to each pin. Resistors will be needed to connect to an Arduino.
Voltage : Red 1.8 to 2.4VDC
Green 2.8 to 3.6VDC
Blue 2.8 to 3.6VDC