The cookie settings on this website are adjusted to allow all cookies so that you have the very best experience. If you continue without changing your cookie settings, we'll assume that you are happy to receive all cookies on our website. However, if you would like to, you can change your settings at any time using the Change cookie settings link in the Special menu. 
+44 (0)20-84520161 Contact Us
Now FREE Delivery on UK mainland orders over £30+VAT

NodeMcu v3 WiFi Module 2.4GHz with ESP8266, CH340 and USB port

  • Details

  • Recommended

  • Send


Item Number
Item Condition
£6.50 (inc VAT £7.80)



  • 40 Female to Female Jumper Cables on rainbow ribbon cable

    40 Female to Female Jumper Cables on rainbow ribbon cable

    Solderless Female to Female Jumper Leads in a set of 40

    This set of coloured female to female jumper leads can be used together or peeled apart into smaller sets or single leads. They are great for prototyping with boards like Arduinos and Raspberry Pi.

    With 10 different colours and 4 of each colour, it's easy to keep track for quick fault finding. 

    Colours: Red, Orange, Yellow, Green, Blue, Grey, Purple, Brown, Black and White

    Length: 200mm

  • 4 way 5V relay module for Arduino

    4 way 5V relay module for Arduino

    5V relay module for Arduino and other microcontroller projects

    This module has 4 x 5V changover relays with the option of using them through optocouplers. There is an LED for each relay to indicate when it has been activated.
    The relay allows the low current microprocessor outputs to switch higher currents and voltages. With the optocouplers it fully isolates the live side of the relays from your microprocessor, this will require a seperate 5V supply to power the relays.
    Trigger voltage : 5VDC
    Supply Voltage : 5VDC (only needed if using optoisolators)
    AC Switch ratings : 250V 10A
    DC Switch ratings : 30V 10A
    Size 73x52mm
  • MQ2 Combustible Gas & Smoke Sensor

    MQ2 Combustible Gas & Smoke Sensor

    Combustible gas and smoke sensor module for Arduino and other microcontroller projects

    This module has a sensitive gas sensor that can measure smoke and various combustible gases. It can measure compunds such as LPG, Propane, Methane and smoke. The sensor outputs a varying voltage on the analogue pin depending on the level of gases present and it has a comparator to give you a digital output when the level of combustible gases reaches a certain level. This can be set with the built-in potentiometer.
    Please note, this sensor needs to warm up for a couple of minutes before it will give a stable reading.
    Voltage : 5VDC
    Current : 150mA
    Sensitivity : 300 to 10000ppm
    Size 32x21mm

Send to Friend

: *
: *
: *
Type the characters you see in the picture:


2.4GHz WiFi NodeMcu IoT Development board for Arduino and other IOT projects

This module uses the popular ESP8266 microchip with full function WiFi as well as its own microcontroller.
It employs the CH340 USB to Serial converter.
This module can be used to add WiFi to your microntroller project. Can be programmed directly from the Arduino IDE to work independently. 
Voltage : 5VDC
Frequency : 2.4GHz
Wireless Standard : 802.11 b/g/n
Dimensions : 57mm x 30mm

Recently Viewed