|Now FREE Delivery on UK mainland orders over £30+VAT|
Horizontal Coin Battery Holder for CR2032, CR2025, CR2020, CR2016, CR2012 Lithium and other 20mm diameter cells
Lamp Holder for MES (E10) 11mm Screw Lamps
Miniature Toggle Switch SPDT Single Pole Changeover Centre-off. On/Off/On
5A @ 125V, 3A @ 250V.
Needs 6mm cutout
Miniature PCB Vertical Slide Switch SPDT 125VAC 750mA max. H10mm x L14mm x W7.5mm. PCB Pins.
Plain Board. Pierced at 0.1" (2.54mm) spacing without copper. 127 x 95mm
Can be cut to size or simply snapped off on a straight edge.
Can be used with CQP1 pins. Made from Synthetic Resin Bonded Paper.
Matrix Board. 0.1 inch (2.54mm) spacing with Single Copper Padded Holes
They are not connected to each other.
You can connect with wires or jumpers. Phenolic 1.8mm Board. 371 holes. 72 x 47mm. Rows and Columns marked for easy identification
MES 11mm Round Indicator Filament Lamp 3.5V 300mA
Horizontal Coin Battery Holder for CR2032, CR2025, CR2020, CR2016, CR2012 Lithium and other 20mm diameter cells.
Login to post a review
Electret Microphone Insert (Condenser Mic Insert). dimensions: 10 Dia x 7mm long. Impedance 300 ohms. Freq response 50Hz to 12KHz. Works from 1.5-10VDC. Small battery will power this unit such as SG13S. 2 Solder Contacts on the back. Change 1K resistor to lower value for lower battery voltage.