|Now FREE Delivery on UK mainland orders over £30+VAT|
1000pF. 350V Feed-Through Capacitor (1nF, 0.001uF).
Old RF stock, but new unused
Tantalum Bead capacitor. 22uF 25V
Stripboard 2.54mm - 0.1 inch Copper Strips perforated at 0.1 inch (2.54mm) spacing 25 X 64mm
Rocker Switch. with Double Pole On/Off 250VAC 16A. Cut out 22 x 30mm
Dry soldering-iron tip cleaner that maintains the tip temperature of your soldering iron.
Leaves a fine amount of solder on the tip, preventing temperature loss and corrosion, compared to a wet sponge.
Complete with alloy dish
Mains Cable 3 core 15A black per Metre. Max length 50M
Strands 3 x 48/0.2mmØ
Cable dims 8.7mmØ
Current 15A max
For complete 100M Drums Please go to ZM56H
3A DC-DC Step Down Voltage Regulator (Buck Converter)
This tiny step down voltage regulator uses high frequency switching to make a very efficient DC-DC converter. It can take 4.5V to 28V and lower it to between 0.8V and 20V at up to 3A (output). The voltage is set with the small in built potentiometer.
Voltage in : 4.5V - 28VDC
Voltage out : 0.8V- 20VDC
Switching Frequency : 1 - 1.5MHz
Maximum Output Current : 3A
Dimensions : 22mm x 17mm
3S Balanced BMS (Battery Management System) for use with 3 x 3.7v Lithium batteries
This BMS is designed to charge and manage the use of 3 lithium batteries. It will manage the balanced charging when used with an apropriate constant current power supply for the batteries. It will also protect the battery from both over voltage and under voltage. It also features over current and short circuit protection.
This BMS will balance charge 3 lithium batteries like 18650 or 26650 or can charge multiple sets of 3 in paralel for higher capacity/current uses. It will also balance charge 3S LiPo (Lithium Polymer) battery packs.
Voltage in : 12.6V - 13.6VDC
Over Voltage Protection : 4.2VDC per cell
Under Voltage Protection : 2.5VDC per cell
Maximum Charging Current : 20A
Maximum Discharging Current : 40A
Over Current Protection : 80A
Dimensions : 60mm x 41mm
Dual Display Panel Meter, 0-100VDC and 0-10ADC
This handy compact panel meter will display the voltage and current clearly. It is ideal for a bench power supply or any project that requires accurate voltage and or current measurement. The meter can either be powered from the supply it is measuring if it is between 4.5-30VDC or from an independant power source.
Voltage Measurment : 0 - 100VDC
Current Measurment : 0 - 10ADC
Working Voltage : 4.5 - 30VDC
Dimensions : (W)48mm x (H)29mm x (D)22mm
Red (Thick) - Voltage in for Current Measurment
Black (Thick) - Voltage out for Current Measurment
Red (Thin) - Supply Positive 4.5-30VDC (connect to voltage to be measured if not using a seperate supply)
Black (Thin) - Supply Ground (Do not connect if not using a seperate supply)
Yellow (Thin) - Voltage to be Measured 0-100VDC