Accessories

Solderless Female to Female Jumper Leads in a set of 40

This set of coloured female to female jumper leads can be used together or peeled apart into smaller sets or single leads. They are great for prototyping with boards like Arduinos and Raspberry Pi.

With 10 different colours and 4 of each colour, it's easy to keep track for quick fault finding. 

Colours: Red, Orange, Yellow, Green, Blue, Grey, Purple, Brown, Black and White

Length: 200mm

Solderless Male to Female Jumper Leads - set of 40

This set of coloured male to female jumper leads can be used intact, or peeled appart into small sets or single leads. Great for prototyping with Arduino, Raspbery Pi and other projects

Keep track easily with 10 different colours for quick fault finding. 

4 of each: Red, Orange, Yellow, Green, Blue, Grey, Purple, Brown, Black and White

Each length: 200mm

Solderless Jumper Leads for use with Breadboard

This set of coloured jumper leads, invaluable when creating circuits with Breadboard. Seven different colours and Four different lengths will simplify your connections, keeping  your work neat and clear to identify. 

Colours: Red, Orange, Yellow, Green, Blue, Black and White

Lengths: 120mm, 165mm, 200mm and 240mm

Solderless Plug-In Breadboard 0.1 inch - 2.54mm spacing.

400 Points. 2 x 30 x 5 commoned points. 4 rows of 25 points. Self-adhesive backing, or use free-standing.

deal for experiments & prototyping.

Solderless Prototype Plug-In Breadboard 0.1 inch - 2.54mm spacing

Ideal for experiments & teaching. 830 Points. 2 x 63 x 5 and 4 x 10 commoned points.

63 rows of 5 points. Self-adhesive backing (or use free-standing).

Can be used over and over again for prototyping circuits.

Useful numbered grid. Accepts IC sockets, ICs and pin strips, transistors, resistors capacitors, LEDs, diodes, wire, etc

Clear Acrylic enclosure for Arduino UNO R3 Board

This custom made box for the Arduino Uno R3 is a simple 2 piece snap together case. It has all the cutouts needed to alow easy connectiion of the power, USB and all the pinheaders. There is also a built in reset button extension to alow easy resetting of the Arduino with a press of the finger (many other cases just have a hole above the reset button). The case will hold the Arduino solidly in place inside without needing you to use any screws. It also has vents on the underside and mounting holes so you can fix the case to a surface.

Dimensions

75mm x 60mm x 17mm